Search results

I like the mustang cop, but i still think the coolest one I have seen is the texas viper.

Thanks, I am greatful

What are some good Mustang Restoration books? I am looking for priming steps and fillers, etc. Kinda what to do first, second, third, etc when it comes to body work prepping. I am still in the metal replacing and welding stage, I sand and prime with etching primer as I go along. When all the...

inside the tire is fiberglassed, the car has a precision power 5440 5 channel amp, MTX speakers, Orion sub.

For my car, I had thought about making a custom harness from scratch to my 67

SN65, do you have a complete list of the materials; primers brands, sanding etc.

Mustang spindles can be grouped into the following: 64.5-67, 68-69, 70-73. The early ones have the advantage to be concours correct, while the latter ones are stronger. 68-69 spindles are larger than the earlier ones but retain the same outer tie rod tapers. The 70-73 spindles are much...

That's what I thought, Paddock parts has a set of 720's w/1" lowering, for $74+. I am going to head over to Auto Zone to by my shocks and a ball joint, much cheeper than order price and shipping cost. There gabrial

The suspensions are the same, you will just need to get the right springs for the load you want and rear axles for the type of power. Much easier switch then if you had a 65-66 V6 to V8, where just about everything is different.

screw that, it took me 5 minutes, I just unscrewed the nut, and hit the ball-joint directly with a hammer. A couple wacks later it became free. I tried hiting wit with a mallet, but it was a no go. However, I didn't have plans on reusing the ball joints, but they look fine and there isn't...

here is a little way.

never mind..

I was reading through a mag and saw this And I knew what I had to have.

Need to buy Coil Springs I have a 1967 coupe, I was needing to purchase some coil springs and was wondering what type. I do not need the Global Wesy! I have searched for a few hours on here and seem to only find people that have 65-66 mustangs and their applecations are different than mine...

I am just going to style it as one, not like I will clone it and try to sell it as such. I will tell everyone it's a 67. And the interior will have leather seats custom, steering wheel by Grant, and etc. I only said that it will look like the 68' CJ because well, it will have a big block or a...

Removing the fake vents, adding the reflectors in the back and front. It will look exatly like the 68, I am either going to put a 428 in it or a ford crate engine. I wanted to clone the 68.5 Cobra Jet car. Well, still I need to know what to spend my money on. I dont' want to spend the...

Do you mean this Book? Also, I am going to be converting the style to a 68, so would it matter with year of manuals I get?

Oh hell yes!!!

Sometimes you have to do what works. The whell wells on mine had an 1" of undercoating and etc that had been built up in it, I took a chesial and went to work.

I was needing the Frame Specs of the 1967 coupe. IF anyone new them or new for sure where I can obtain them. I wasn't sure if they could be found in the Shop Manual.