Search results

Ok, I got the car started, I went through all the plugs and electrical connections and disconnected/reconnected them, removed all the plugs, re-seated them. Then just for grins, I charged the battery. She coughed and gurgled, but eventually turned over. So now I am seeing white smoke from all...

Ok, I feel like a schmuck.....I realized that I didn't block the Throttle Body open to full throttle when I did the compression test, my guess would be that is what explains the ridiculously high psi and the launching of oil out through the open spark plug well. Once I realized that, I...

The two "oily" plugs are from the drivers side (opposite of the oil fill) How do I determine if the valve cover gasket is leaking? Is it just a replace it and see what happens kind of thing? The motor was running fine, with the exception of occasionally it would bog down and run very...

LOL Thanks for the reply...again! the plug wells had a little bit of dirt/grime/oil on walls, but it looked like it had been there a while. I could see the "shinyness" of the aluminum at the bottom of the wells, so I don't think it was leaking in from the top..... Here's a picture of the...

I was changing out my plugs today and found two of them covered in oil (the thread/electrode end)…the oil was wet (not burned on the plug). My first thought is piston ring going bad letting oil into the cylinder…..what are your thoughts? Any other causes of this? If that’s the case…how...

Does anyone have a How-to write up on Valve Cover/gasket Removal and replacement? I am just a little worried about removing the fuel lines, etc...the valve covers themself are pretty straight forward. Any tips/advice would be a great help. thanks! Also while I have them off to replace...

Orlando!!! GO to law school at Barry University! Active member of www.yellowmustangregistry.com

You have one mighty nice ride there!!! :worship:

Yea he got taken on this one, LOL :bang:

Everyone is correct, you didn't damage anything. Although I wouldn't make a habit of it! :D

They came out just fine w/ an open ended wrench on my '98...jack her back up, crawl under there and put some elbow grease into it!!!

Sweet!!! :banana: I can't wait to do it one day.

You'll get the most "feel" out of the gears, so if you want the best bang for your buck go with that.

Weld them bad boys in place!

Test

Ok, I am getting ready to put a 1 3/4 in. drop on my 98 Stang. I also need to replace the shocks. What do you guys recommend to replace the factory shocks with that isn't gonna cost me a fortune?

By God!!! There'll be an a$$ whoopin'

I'm BACK!!! No one can keep a raccoon out for long!!!

Pappy, we know the feeling!!!! I have been forced to actually do work, What the HECK!!!! :mad:

OMG!!! The twitching won't stop!!! neeeedddd YYYYMMMMMRRRRRR :crazy: