Search results

I am running a Spec stage 2+ In my 86 SVO and it pulls strong

you are damn lucky you're not picking cast piston shrapple out of your butt!!!!! get some FORGED pistons in there, PRONTO !!!!

All of them can be done without removing the steering assembly.

what size are the door speakers in a fox body?

thanx guys for your help im sure it will help.

does anyone have a thread on how to do the wiring for a 3G upgrade in a foxbody?

I have a grant wheel on my 92 coupe and i used an adapter. i would check on the grant website, you should be able to find one there

thanx for your response,it wasn't to hard and took less than an hour start to finish. the only thing i did differently was put in bolts with locking castle nuts instead of the rivets cus i couldn't find the right rivet gun.

can anyone tell me how hard it is to replace the glass in my 92 coupe (drivers door)

I sure hope you put some dielectric grease on the back of the module when you replaced it ( it is a heatsink and needs a good contact ) or it will overheat and you will be replacing it again SOON !!!!!!

thanks for the diagram rustbucket, I am picking up the relay and a new temp sensor today this looks like it should be a good fix. :nice:

89 wheel and column and it is best and easiest to do the whole column and everything hooks up. I got rid of the airbag wheel and im using a grant wheel and adapter and moved the cruise controls to the gauge cover on the dash.

$176+ tax at crappy tire and make sure you use some dielectric grease on the back of the module when you put it on or you will blow it too. the classic symtoms are tach only shows half the rpm's and it should throw codes 223-224 if it is the module.

I have 6.5 s in my doors and if i had it to do over i would go with the 51/4" ones these fit right in with no mods necessary

when you remove the arial cap on the fender there should be screws to mount it to the fender. now with it loose from the fender go inside underneath anf find the antena plug, it will most likely be at a 90% angle ,straighten it out. tightly secure a piece of 12-14 gauge wire on the end of the...

when you hook them up the way i suggested they will be in series and they sound great. the 3.5" I put in the dash are ceramics.

I just finished doing all this. the dash and the door seakers are on thhe same channel. I left my dash alone.( well, not really cus im doing a heater core) for the door wiring, all I did was go the the dealer and get the connectors that match up to the factory door speaker harness and wired...

thanx red

what years did the 2.3 turbo come in the t birds ?

make sure you warm the engine up to normal operating temp. before you start pulling codes.