Search results

I've got three new-in-the-box universal Magnaflow high-flow metallic spun catalytic converters (59955) for $75/ea plus S/H if needed ($94 on eBaymotors). The are the most free-flowing and smallest of their like of converters and the same ones I used to replace my stock converters on my '86 GT...

I've got three new-in-the-box universal Magnaflow high-flow metallic spun catalytic converters (59955) for $75/ea plus S/H if needed ($94 on eBaymotors). The are the most free-flowing and smallest of their like of converters and the same ones I used to replace my stock converters on my '86 GT...

I've got three new-in-the-box universal Magnaflow high-flow metallic spun catalytic converters (59955) for $75/ea plus S/H if needed ($94 on eBaymotors). The are the most free-flowing and smallest of their like of converters and the same ones I used to replace my stock converters on my '86 GT...

I've got 3 unused Magnaflow metallic spun catalytic converters number #59955 for $75/ea. They're 8 inches in length, 4 inches in width, and 2.25" center inlet/outlet.

88GT GasStationFront

88GT Brakes

88GT Hatch

I've got it at .89 and I'm still getting the intermittent idles surges in and out of gear. I've got mods on this SD car (65mm tb, full exhaust, and CAI), so I'll probably have to just live with it knowing they don't respond to bolt-ons as well as MAF cars.

Thanks for the great advise. I've checked for vac leaks but found none. I'll check the housing and setting on the tps tomorrow. .97-.99 on the tps, right?

Thanks a lot Guys. Very helpful. I notice a lot of you are saying the idle should be 650-750rpm. My idle is at 950-1000rpm all the time, even with the new IAC and idle adjutment plate between the IAC and throttle body set at the lowest idle.

My '88 GT speed density is doing some intermittent idle searching from 750rpm to 110rpm over the past few days. It's not a constant problem, only when cold or idling in park on occassion. If I tap the gas while it's surging, it will almost stall sometimes. It runs wonderful otherwise. I've...

Install Complete Thanks for all the feedback and opinions Guys. I got it all mounted at my shop today. Really straight forward, as mentioned above. Just some accurate measurements to make sure it's level and true, then tighten her down little by little, alternating sides to torque it evenly. I...

Has anyone installed an SMR rear strut tower brace on a fox body yet? I'm just curious as to what is involved.

It seems the the eletrical gauge is it. I'm still unsure on how to install. I've seen electric fuel pressure gauges for $20 on ebaymotors. They have the 1/8" terminal on the back. It seems you can buy the brass fittings to screw into the schrader valve (Home Depot), then a sending unit connects...