Search results

you still need the cable to put new tunes into the xcal1, unless you want to send in your xcal to your tuner everytime you want a new tune.

you can download the software from sct's website and check it out. you can change fuel, timing, shift points for auto trans., tire size, gear size, rev limiter, two step, and speed limiter. download it and check it out for your shelf. also without the cable you can not put new programs into...

on my et streets i run 1.8 60' times. with a little more work you should be able to hit that, especially if you could heat the tires up.

that when mine started happening. and same thing sometimes its there and other times it not.

i dont think mine is the exhaust, i fixed all those problems already. its more of a rattling noise coming from someting that is lose. it sounds like it is coming from the front of the car, NOT the rear like the exhaust noises.

does anyone else have a rattle under the car when accelerating from a low rpm?

mine was the same way. i ended up putting a screw driver through the thing to twist it off.

i am running mine off of an aftermarket amp. but some other people on TMS are running them on the factory amp. but to do that you need dual voil coil speakers which MTX does not have.

the MTX 4500 8" fit. i have them believe me.

you have to remove the bolt in the back of the speaker. take the door panel off and and the speakers is bolted in though the back of the enclosure.

i know a couple people that own stereo shops. i took a shot on the mtx 8", nobody i knew had them.

after testing the kicker ssrmb8 and the memphis component 8" against my mb quart 8" i came to the conclusion that they were all just mid bass and all sounded pretty much the same. so i tried out some MTX 4500 8" today and for just slapping them in the door with an unmodified factory enclosure...

http://www.memphiscaraudio.com/ look for a dealer in your area. yes they mount without any modifaction although if you are planning on using both speakers you will have to run set of wires though the door which is hard.

i tried out the mb8 and memphis component 8" with tweeter. both sounded better than the mb quartz mid bass 8" i'm using now. so i will be upgrading. also i noticed that MTX makes a thunder 4500 8" that will fit. dont now the quality or sound.

please let me know what you end up going with. the only other option i see is make a speaker ring thick enough to mount the speaker to so it brings the magnet out, and miss the side of the enclosure. i thought about fiberglassing a enclosure but the door itself is formed the same way.

i dont remeber the depth but it is pretty deep. the only bad thing is that i wide magnet aftermarket speaker will not fit because the encloser comes in close to the magnet. i found a set of mb quartz 8" mid-bass to replace stock ones. sounds great. i wanted to put the jl 8", the enclosure is...

does anyone know the wiring of the stock system? where the amps are located? i am tring to install a amp on the factory speakers along with installing an amp and sub. thanks

where can i find a mmr air intake and is there any way to tune the ecm without buying the sct xcaliber. thanks