Search results

  1. Dbeck002

    A/C Clutch will not engage, but air will blow.

    I just did the test and i heard the AC clutch click on. Looks like my system was low, i guess there is a leak somewhere. At least it wont be as costly to fix now that i know its just refiregerant, thanks again.
  2. Dbeck002

    A/C Clutch will not engage, but air will blow.

    Thanks Jrichker, helpful as always. Im going to jump the two terminals on the canister and see if that helps. BRB.
  3. Dbeck002

    A/C Clutch will not engage, but air will blow.

    Not too long ago i had my A/C fixed, it was working fine. Just the other day i turned it on and the fans inside the car would blow but the A/C clutch to the compressor would not engage. I probed the connector going to the A/C clutch and it shows around 8 volts when the car is on. Is there a fuse...
  4. Dbeck002

    140 alternator upgrade - wiring question

    Is it necessary to keep the stock orange/black power cables wired up to the 3G even after using heavy gauge cable?
  5. Dbeck002

    Trivial Electrical question.

    UPDATE: <vent on> F--king bull**** load boss alternator from ebay was the problem, it always is. this is the 3rd time it fried on me. POS, i will never buy a load boss again. All you guys out there hear me, do not buy a POS^2 load boss alternator. </vent off> I put my stock alt...
  6. Dbeck002

    Trivial Electrical question.

    well its not a ground that i measured, its the yellow accessories cable that goes to the solenoid. I do not know why my alternator is not charging, the only thing that could possible be doing this is my KOEO 12v source to the alt to activate it. If the alt is not getting the signal to...
  7. Dbeck002

    Trivial Electrical question.

    Infact, it may not even be the yellow wire as the culprit. It has to do with the alternator not charging. But the issue seems to be fluctuating around.
  8. Dbeck002

    Trivial Electrical question.

    The meter reads that there is zero resistance which means a closed circuit between that wire and the ground which means battery current can short through there. also, i drove for 2 minutes then the voltmeter drooped down to showing cnostant low voltage which means alternator aint...
  9. Dbeck002

    Trivial Electrical question.

    1991 5.0 EFI. There is a yellow cable (about 10 gauge) going to the battery side of the starter solenoid. I unplugged it from the solenoid and isolated it (just the eye lug thats on it) i tested for resistance to ground. It shows no resistance to the chassis or engine. This means my...
  10. Dbeck002

    Skinnies question.

    90Notchback thanks for the input. Your car is Badass. The front tires do not look out of place at all, i think i will go that route. BTW are you in florida? I go to moroso every now and then.
  11. Dbeck002

    Whats the most power anyone ever got out of a h/c/i setup? stock bottom.

    I've seen people bolt AFR165s, custom cam, and a holley intake on a stock engine and make 330 rwhp.
  12. Dbeck002

    Skinnies question.

    I just got a set of 4" skinnies for 200 on ebay. im stuck with those i guess, i think a 165 tire will be ok, im not a crazy driver. By the way, i know many many people that have 275s on an 8" welds and they never complain. I was just about to order 8", should i go 8.5" ?
  13. Dbeck002

    Skinnies question.

    I see, i wonder what a 185 tire would look like. Kind of like a compromise between width and fitment. Has anyone used a 185 tire on 4"? If so what company and height? Thanks.
  14. Dbeck002

    Skinnies question.

    Well if everyone runs a 165 tire on a 3.5" rim i dont see anything out of proportion with a 195 tire on a 4" rim. I just want a little more rubber on the road, thats all.
  15. Dbeck002

    Skinnies question.

    What do you mean real short? Is there such thing as a 185 tire?
  16. Dbeck002

    Skinnies question.

    I've been searching this topic for the past half hour and cannot get a definitive answer. I just bought some 15X4 draglites for the front. I do not want to mount 165s on them because i drive this car on the highway daily and i would really like the safety factor of a fatter tire. Can I mount...
  17. Dbeck002

    what need to be done put bigger valves into stock e7s??

    foxfan you better have 3 or 4 sets of stock heads laying around because youre gonna mess up since its your first time. Porting requires a lot of skill and experience, especially when porting heads. There is a whole science behind head porting, doing it yourself will not net you a huge gain. I...
  18. Dbeck002

    OK, time to think about 331...

    Attacking a group of people because you couldnt think of anything smart to say is definately not cool. :nice: