Search results

Wil I be able to run this in my car? Will I be able to connect the proper power wires and speaker wire and be set? Just wondering. I want to keep that factory type look. I dont have tint on my windows.:D

ttt

1011-1 or 1011-2? I have been running 1011-2. Which is better? Opinions on each...

There has been a change of plans. I'm not going to O-ring the heads at this time. What would be the best head gasket to run with non o-ringed heads and block with supercharger? Copper?

I am having my heads O-ringed and was wondering if this headgasket would work. Some people on other sites were telling me to use the FELPRO 9333 PT-1's. Any help on this would be greatly appreciated

T45 input shaft It is longer than the T5. My buddy tried to use a tranny that came out of a '94 Cobra in a '91 GT and it wouldnt work with the T5 bellhousing. He had to get the bellhousing from the '94, and it worked just fine. Good luck!

! I'm running GT40 heads with the springs that came on them, with E303 cam and Cobra 1.7rr :D Car runs good. I also have a stock bottom end.

I am from Gadsden, Al. and I was wondering if anyone in this area or surrounding area would be interested in helping me start a Mustang club for this area? I am very interested in doing this. I'm not really sure what it will take to get it started but I'll do my best to find out and get it...

I have an E-Cam and it works great! My car pulls hard versus when it was stock. Check my sig.

I just checked back and my heads are the y303 also. I think I'm going to take my car and put it on the dyno, just so I'll know the rwhp. Thanks everyone for the input. Its greatly appreciated.

Thanks!!!

I have Mobil 1 Synthetic in mine, and its been working great. My tranny has 93K on it.

Not really a guru on cams, but I just installed an E-303 cam in my notch and I love it. Nice lopy idle. I also installed heads and intake at the same time. I can tell a big difference in my car and my buddies car since my mods. Before mods, our cars had the same setup. Hope this helps

I turn my timing down to 10 degrees when spraying. My plugs are gapped at .035. Still trying to figure out whats the best plug to run with my setup. Part/Plug#????? Suggestions anyone??? I'm running autolite's now.

Just put a hose on it and block it off. You will be fine. I did before I switched over to a o/r x-pipe

I'm from Gadsden, Al. and was wondering if there were any Mustang guys from Gad. on Stangnet? If so, holla at me. Maybe we can get our own club/organization started. I'm with it... Holla!! :D

I know this is sorta late, but I thought I would chime back in and let you all know that I have completed my mods. I ran a 13.61 @ 105mph still on nitto's, spinning like crazy on motor. I went back after hooking my n02 up and some et streets and run a 11.81 @ 118mph after my 3rd pass. I'm...

I installed my rockers and some of them opened the valves and they ended up working perfect. I guess it depends on where the pushrod/lifter is on the cam. Could be that the valve should be on that paticular cylinder. I hope I understand exactly what your saying.

What size rockers are they?