Search results

I am running one - I will check that as well, thanks guys.

Thanks will look into all this tonight....

I am having what I assume to be some carb issues. Lately it will stumble when wide open then also surge while just cruising. It does not happen everytime I run the car but often enough where I guessing something needs to be adjusted. Is this a Jetting issue or what else could it be - I...

It is a flat tappet and the XE268 was one I was considering. Also if I go with new roller rockers what pushrods do I get?

Thanks - I guess I should clarify I don't really need it to stop at 5500 but it's not a strip car so I don't need it to pull on upwards of 7,000 etc......

Hello everyone, I need some opionions on what off the shelf cam I should go with based on my current set up. 600 Holley Carb, RPM Performer Intake, Ford Racing Heads Y303's, Hooker Headers. I am looking for a real solid street cam to come on early and go to maybe 5,500, what should I go with.

when switching from 1.94 valved heads to 2.02 valves do you always have to fly cut the pistons?

Has anyone used any type of Gasket sealer to keep the gasket from sliding around, does this help?

Ok I need some help and or some tricks of the trade in regards to a timing cover leak. I have replaced the timing cover gasket twice and both times I cannot get rid of the leak. The first time it leaked and accumulated oil in the little valleys next to the middle bolts. Now the second time...

I am looking at upgrading to this cam, and I have a 2 part question. #1 is this a good match to my current components which are listed in Sig. #2 will there be any clearance issues or will I have to upgrade the springs. Thanks

This is the Ford Cam I have if this make a difference - M-6250-A312* (1) 289/302 Flat Tappet Hydraulic 3500 5000 290° 300° 0.472" 0.496"

Quick question for everyone.....I am planning on switching from FMS Y303 heads to AFR 165's and getting a "streetbeast" flat tappet cam done by Ed Curtis. What kind of gains could I expect from the switch?

My block is out of a 89' but I am running an early style timing cover. Does anyone know what part # I should be using for the timing cover. I am looking at Fel Pro. Thanks

Oil.

I have a small leak coming out of the top portion of my timing cover which then drips and pools in the valley in between bolt holes. My question is is there any thing I can put on the spot where it leaks to stop it without replacing the gasket for the 3rd time? After the 2nd replacement there...

what is the fluid capacity of a fully drained standard radiator on a 67 mustang?

Thanks that's what I thought but I was hoping I could get away without doing that again.

I recently had the front of my engine apart for repair and now it's back together but I have a leak on the bottom portion of the water pump. My question is do I have to drain the radiator again to take off the water pump to fix the leak. I just put it back on and I am trying to avoid...

Thanks

does anyone know what the torque rating is on the bolt that connects the fuel pump eccentric to the timing cover?