Search results

Here's a link to the air bag codes for a 90-91 http://www.veryuseful.com/mustang/tech/airBag/airBag90-91.html

I'm assuming it's the blue box behind the radio. Also, the code was from the number of times the Air Bag light is flashing, not pulling the codes. Are the Diagnostic Monitors available aftermarket?:SNSign:

Code points to the air bag diagnostic monitor. Anyone know where it's located and where I can get one.

Thanks for your help......

Put a fork in me I'm Done...... OK, went with your advice, and here's what I've got. 91 degrees outside air Low humidity Air on Max, doors open Fan on high. Suction 26 Discharge 245 Engine idling at 800 rpm I have a 33 degree drop between air entering the HVAC unit and discharging at...

When the new compressor went out, the compressor was fine, it was the clutch pack that went out. Since the compressor was still under warrenty, they gave me a whole new compressor, insteady of just the clutch assembly. I swapped out the compressors, added about 6oz of additional oil...

Total, everything. The original replacement compressor went out about a month before the warrenty went out. Clutch pack. Installed a new one. Added some additional oil, vaccumed, charged with 2 cans of R134. Went back about a month ago, when the temp. outside started going up. That's when...

Thanks,

So, does low pressure, high suction indicate a low charge.

Did a total r12 to r134 conversion several months back. Just getting time to fool with it again. Been to hot. It's 74 degrees out with low humidity. Engine idling at 1500 rpm AC on MAX, fan on high. Suction side pressure 65 Discharge side 205. Suction side looks a little high. Is that a...

4 flashes, pause, 4 flashes. Any ideas? Just started, car has been sitting about 2 weeks. Started it, then the flashes started.

I noticed the other day, after I filled up, that my gauge showed just over a half tank. I had the instrument panel out last year, but hadn't had any problems. Is there a way to test the gauge to see if it's receiving the correct voltage from the gas tank. Also, is there a way to check the...

I bought the complete clutch assembly from AutoZone, but it's not assembled. It looks like there's 3 main pieces, snap rings and about 5 or 6 small washers, which looks like the shims. I ask him if it didn't come already assembled and shimed. He said no, at least not from them. I guress now...

Can someone point me toward a site or someone from the group for swapping out the clutch assembly on a A/C unit, plus clearances for the clutch assembly. 90 Mustang GT. I did a R-134 converson, all new parts, compressor is fine, just the clutch died, lasted 1 year and 15 days. Out of...

So is it less likely to leak under pressure instead of under vacuum?

Anyone????

I replaced the entire A/C system last summer, I replaced everything... The new compress that I bought, the clutch assembley started making noise, so they gave me a new compressor. I replaced it yesterday and vacuumed it down. In 24 hours I lost about 2 lbs. of vacuum. Is that normal or do...

AOD leaking from the rear tail shaft! Short trips are not to bad, but if you get out on the interstate, it will really leak. Do they have a rear seal that can go bad?

It has a rebuilt compressor. Is it possible for the oil to leak out, but not the freon? Could I have a bad compressor with bad seals? It's leaking out the bottom end of the compressor like where it was assembled, not at any of the fittings.

But, if you don't run it will it cause the "seals and or gaskets" to leak. I've never seen one leak this much. A spot on the driveway about the size of a basketball!!!!