cam swap

I was just given some “Brodix BP ST 5.0 R Series Cylinder Heads CNC Ported” by a friend and was wondering how these would fare on a SD car? So far my 87 Notch has a 306 with mods that include Intake, BBK 70mm Spacer and TB,BBK long tubes,BBK Off Road Cats with X pipe to stainless piping with...

I've been considering doing some power upgrades to the 302 and I'm debating weather to go with a new cam or go with 1.7 rockers... Its a carbureted '85 HO running flat tappet currently. Nothing is done besides emissions removal. I WILL put either a pair of GT40 or GT40p heads on before this. New...

hey, guys so I just bought a new cam and lifters that I'm gonna install in my 71 302. I wanted to see if yall knew how much preload I should go with when I tighten the rockers down? the cam isn't anything crazy here are the specs on the flat tappet.... ?Also is this a good performance...

3 years ago I bought an 89 5.0 foxbody that was crashed to save the engine. The engine has the edelbrock performer top end kit on it. This week i took the engine apart to install new rings bearings etc. and pulled the cam out to find out the specs. It has a part number on it. It has "EDEL"...

Hey Guys, I have an 89 LX 5.0. It has: GT40 heads Edelbrock intake 75mm tb Upgraded injectors/fuel system Shorty headers (bbk) Bbk cai Open exhaust into 40 mufflers 4.11s I'm looking for a cam that is comfortable o the street, but slopes really hard. I know this sounds funny, but I would...

Just need something thats louder and provides a good boost in HP without having to add other mods.

Hi there I am new to this site and I actually do not have a mustang, but I do have a 2000 Explorer with the 5.0L. I am going to be upgrading the cam and I was hoping some body that has some experience with doing so could I've me some feedback about which cam to go with. Right now have found a...

Hi there I am new to this site and I actually do not have a mustang, but I do have a 2000 Explorer with the 5.0L. I am going to be upgrading the cam and I was hoping some body that has some experience with doing so could I've me some feedback about which cam to go with. Right now have found a...

So i have finally figured out the p0340 problem on my 2000 mustang gt. It turns out that after checking everything that the magnet or metel piece on the cam gear is no longer working. The sensor is not recieving a constant signal from it. And of course i have the windsor engine so i cannot just...