engine

If anyone is interested I am parting ways with my (ZERO "0" Miles on it) 4.6L Aluminator Iron sleeved DOHC Engine assembly. It is a built for boost via Centrifugal Style Supercharger (I do not have a Supercharger for this car) stuffed with a 298ci STROKER rotating assembly from Livernoise...

hello there looking to get some help, been running around in circles trying to figure out what is wrong with my coup, Here is the back story I bought an 89 4cyl hired someone to do the v8 swap due to no time and not having the experience to do it myself. Used a 91 Convertable Lx automatic car...

Hello everyone! So I'll make this short n sweet. I bought a basket case and I'm not giving up on this one. So with that said I need help with where to buy bolts and nuts that did go with this 1966 coup? Also was a straight six and came with a 302 with some sort of serpetine belt set up. Dose not...

Hello i have a 1999 mustang gt i just got, it has BBK long tube headers, i got the bold taken out from transmission now when i came to the point of dropping the transmission the passenger side of headers is stopping me from complete taking it out what can i do i need help should i unloose the...

Hello Stangnet! I've noticed the C4 in my '67 vert is starting to take a while to engage when cold. I realize that this may mean a rebuild to replace all the worn junk inside. Not sure of the history of the tranny, but suspect it has never been rebuilt. Right now, I have the numbers-matching...

For about 6 months now my car has been having a small Tap when I ONLY push the gas pedal down a little, also when I release it and it drops rms it starts again. Sounds like if you were to tap the plastic on the dashboard with your finger. Sounds like it's coming right where the tranny and engine...

Hey guys, I'm new to this forum, I've always loved mustangs, and I finally got one. It's a 91 lx hatch. I've had some trouble with it, but I have most of the problems fixed except for this vibration one. The shifter will vibrate like hell above 3000 rpms, whether I'm sitting still or going down...

Hello, I have a 1989 Foxbody Mustang 5.0 and whenever I give the car full throttle the engine starts to die. It makes popping noises under the hood and if i keep my foot pushed down on the throttle all the way the rpm drops and it just makes popping noises. I replaced the fuel filter and have...

RENALDY75 4.6L, 2 valve 2002 engine in a 1997 mustang GT this engine is fully build with 515hp 14psi

RENALDY75

walk around to show how straight and clean it is. It has a big lumpy cam but the wind was too much and the sound is bad.

Please LIKE my Facebook, if my videos are useful to you: http://www.facebook.com/OperationMustang Mustang Engine Differences