speedometer

  1. P

    e

    Hel
  2. D

    ‘01 Cobra Speedo off

    Any advice as to which box to buy to reset my speedo. Previous owner upgraded to a numerically higher tear end and speedo is off between 11-16 mph. Of course it is recording miles faster too. Any advice or guidance would be much appreciated.
  3. DrSmart

    94 GT Convertible Speedo Electrical Issue

    The speedometer quit working years ago when my grandparents owned the car. They bought it new. About 2002 my grandfather took it to get inspected and it quit working after the inspection. I have change out the gears a couple of years ago, but I don't remember seeing the burned connection...
  4. Keith5.0GT

    Frustrating Foxbody Speedo

    hey everyone. I’ll make it short. My speedometer and odometer just quit working. The cable and gear were fine but I replaced them anyway. I looked into trans opening and saw the gear on the input shaft, seemed good and didn’t spin by my finger. The cable can move speedo needle by hand so the...
  5. MafiaMustang

    Digital Speedometer

    I'm looking to convert my 1990 fox over to a digital speedometer. A few reasons.. I keep burning the cable even when I ziptie it out of the way. Also I like it better. I've looked online and haven't found much on doing a conversion or parts available. If anyone has done it or has any Ideas I...
  6. Tom Winkler

    Axle Code 2

    I have owned this car a few years, it is a nice little car I enjoy driving almost daily. The couple I bought it from were unable or unwilling to tell me much. What I saw is what I got. Having tended to the more stinky stuff I am touching details. A GPS has been the speedometer since learning its...
  7. G

    Speedo Calibration

    I have a 96 gt mustang that has been modified with 3.73 gears in the rear end and my speedometer is showing a lot faster than I am really going. I've been told I just need to change the gear on the speedometer cable to match that of the gearing in the rear end. My question is where can I go to...
  8. LoganCT

    SN95 3.73 Gear Change For Automatic

    1994 GT Automatic Transmission - I know that information is scattered around, but have been unable to find a complete guide on the steps for swapping stock gears out for 3.73s on an automatic transmission. I know that when changing gears you have to get the speedometer adjusted and shift points...
  9. Dillon Terry

    Electrical 2000 Mustang Gt Speedometer Issue!

    How's it going boys, this is my first post on stangforum, but I've been on for weeks reading other posts and searching and so far I didn't find anyone solving this problem. 2000 GT Mustang with a 5 speed manual. When I accelerate down the road the speedometer doesn't start working until I'm...
  10. Dillon Terry

    2000 Mustang Gt Speedometer Issue!

    How's it going boys, this is my first post on stangforum, but I've been on for weeks reading other posts and searching and so far I didn't find anyone solving this problem. 2000 GT Mustang with a 5 speed manual. When I accelerate down the road the speedometer doesn't start working until I'm...
  11. R

    Speedo Over 150mph When Traveling At 50 Mph???

    So I bought this 97 gt coupe for 1300. I knew it would have some issues. Well I put a rebuilt transmission in it with new clutch and flywheel as well as new cable and quad. Mechanic says someone cut the wires for the vss so I got a replacement for him and he installed it.(the speedo didn't work...
  12. N

    Electrical Instrument Cluster Failure

    Hello, I have a 1994 mustang gt with major speedometer and odometer problems. Neither the speedometer or the odometer has worked for a while. I pulled the instrunent cluster to check the worm gears many have suggested and found then in tact. I did however find a burnt wire on the back of the...
  13. THEUNDERCOATER

    Ribbon On Back Of Instrument Cluster?

    hey guys I pulled the dash apart and removed the instrument cluster to check the bulb for my alternator light and the wiring because I've beenchasing a charging problem. The previous owner had just installed an autometer speedometer and had "wedged/cut" it into the existing cluster. When I...