vibration

Ok I’m stumped. 1995 mustang v6 car converted to 5.0 I pulled the block this fall and took it down to the bare block. Got it bored .030 over, like honed, new plugs, cam bearings decked the block and got a scat street/strip 347 stroker kit installed. Here’s the rest… 347 stroker Ford F303 Cam...

I've got a vibration between 2000-2400 RPMs that gets worse with clutch engaged. It does it in all gears going any speed, or revving. It gets worse with load too. Not quite sure what it could be. I can feel it the most when I rest my hand on the shifter. Balancer? Clutch plate? Trans input...

I own a 1986 GT and I have noticed that when driving on the freeway going 70 mph or higher, after I release the gas pedal to slow down a bit I hear a deep vibration noise coming from the back right wheel area. It sounds like something is whining but it is a very deep tone. The car leaks brake...

My 2014 GT has a vibration when letting off the gas coming from right below the shifter it has the MT-82 trans has anyone else had this problem it’s only when decelerating

Hey guys, I am new to the Cobra world. I purchased a 2004 cobra convertible about a month ago. I knew it needed a few things because it sat for so long. there was a loud howl from the rear so I just had a shop rebuild the gears in the rear with stock 3.55 its perfect. super quiet. There was also...

Okay, been chasing this issue for awhile, previous owner says its a rebuilt t5 with 5k miles on it. After driving it for a few months i was going about 50 dropped it to third and gave it hell. after that i had blown my coolant hose off and over heated. pulled over put it back on, took off and...

Alright I have been chasing the cause of this noise since I got the car 5 years ago. The noise started showing up when I would be turning right with the car in 3rd gear at about 1800rpm. If I were to push the clutch in, the noise would go away. If I revved the engine to ~1800 rpm in neutral...

Hey guys :), really looking to get to the bottom of this... I had taken my car to my local Gerald's who do good work. And they checked my entire front end. Called me and said that the passenger outer tie rod was shot, driver inner tie rod shot, bushings for my front suspension shot, front/rear...

Is there a difference between a harmonic balancer for a standard transmission vs. an automatic transmission? I have a 2001 v6 with an automatic and when I purchased this vehicle they threw in another motor that was a manual configured for a manual transmission (I only know it was manual...

Hello everyone i've got a bit of a weird issue that I can't seem to figure out. I recently brought my car into a shop to get my shorty headers installed after my DIY failed attempt caused the EGR seal to break and that came with check engine lights and running lean codes and I just gave up...

Hi there, Strange question, I had both motor mounts and tranny mount put in my mustang last week. I noticed right away when I got in the car and started it up that I could feel a crazy vibration in my seat and in the steering wheel that wasn't there before. While accelerating, I notice a large...

Hello, A while back i bought a 2002 mustang (base) 3.8 automatic for $400 on craigslist, it ran and drove fine besides the 2 spun rod bearings. I went to the local pull-a-part and bought another 3.8 from a 2000 mustang that was a 5spd. I swapped over all the 2002 sensors onto the "new...

So this is my third post about this and I haven't fixed it yet. After a clutch job two summers ago I've had this horrible vibration at high speed not rpm dependent just speed dependent. We bought the flywheel from oreilys we changed everything but we did not change the pilot bearing or atleast...

Hi, New to this forum. Wondering if anyone would have any suggestions on a vibration that is felt from 2300rpm+ which is making my car pretty unbearable to drive at any speed above 45.. I've replaced the ujoints front and rear on the driveshaft this past summer. Tires are "fairly" new but it...

I have been having some engine vibration for about a week now and I can't seem to figure it out. The whole engine shakes in idle and throughout the rpms (though it is worse around 1200 rpm). It also has a cough coming out of the back right tailpipe. There is also a rapid clicking type noise...

I have been having some engine vibration for about a week now and I can't seem to figure it out. The whole engine shakes in idle and throughout the rpms (though it is worse around 1200 rpm). It also has a cough coming out of the back right tailpipe. There is also a rapid clicking type noise...

Hi Im new to stangnet. I have been having an issue with my 2002 Mustang 3.8L V6. When I turn it on I can feel a very strong vibration throughout my car. I can mostly feel it coming through my steering wheel. When I speed up to higher speeds my car feels to ease on the vibration to the point...

Hello i have a 1990 mustang gt and it sits lower on the rear driver side than anywhere else. Ive read a lot of stuff about the "foxbody lean" But mine only sits lower on the rear driver side. The front is just fine. If i remember correctly it didn't do it when i bought it it only did it after i...

have a 99 by 4.6! First off when I start it it jumps to about 1500rpm then creeps down to 1000 and just hangs there. I put a new iac on and nothing. Second, while I'm driving around 40 mph my card starts vibrating I can feel it in the dash almost like its shuddering. If I floor it, I wants to go...

I have a '67 vert 2v 289 with a C4. Engine was just rebuilt 5k miles ago, and runs great at slow speeds. However, once I get above 50 mph or so, the car begins to shake violently, but not always. Sometimes it's as smooth as an Audi. When it does shake, I can really feel it when I put...