You could but.......Not much to report...... just a little more clean up and painting.
Got the rear end cover Rust reformed, primed, and painted:
I also got a lot cleaned and painted underneath. I still need to unbolt the clamps holding the fuel lines so I can get behind them...... but I’m getting there.
And as you can see, at one point in its life, somebody hit the right rear on a curb.... shoved the whole rear to the left, as evidenced by the dents that were created by the driveshaft.
If I was really crazy, I’d pull the rear seat, throw some heat on that metal and try to get rid of the dents to make it look a little better, but I don’t think that will happen...... maybe!
Bolts delivered this morning. Of the ten that were supposed to be in the box, I got 2.Just ordered a set of these from McMaster for the rear end cover. Can’t go for the aluminum girdle cover right now, but these bolts will brighten it up a bit.
Just someone getting a delivery reminds me of how much I hate them.Yeah..... they were supposed to be delivered yesterday, so that part is on FedEx..... but whoever put the box in the envelope obviously wasn’t paying attention, didn’t care....... or maybe an honest mistake
Really wishing I had thought about about all this clean up and paint when I had the tank down last time. Right now it’s full, with a bottle of Stabil in it. Once I run it down again, I’ll drop it and get it all painted to match up above and around the tank.?
Not bragging, but the underside of my floor is cleaner than the top side of 95% of any member’s car in this forum.
Ya’ll are a bunch of lazy asses.
Yeah..... they were supposed to be delivered yesterday, so that part is on FedEx..... but whoever put the box in the envelope obviously wasn’t paying attention, didn’t care....... or maybe an honest mistake