351c 2v Heads- FRESH

Discussion in 'Engine and Power Adder' started by 351carlo, Feb 20, 2006.

Thread Status:
Not open for further replies.
  1. 351c Heads
    2.05/1.71 Manley Stainless Valves (220 new)
    3A valve job
    New seals
    Comp Cams 972-16 Springs and Retainers/Locks
    Crane Rocker Conversion Kit 3/8 Studs/guideplates

    Heads are proven low 13 second/high 12 second performers, easily more with a home port job or a larger cam/ higher compression than I was running. There are 1200 miles on these heads. I have well over double the asking price invested.

    $350 OBO +Shipping

    If you need roller rockers, I will include them for an additional $100 dollars WITH polylocks.
  2. where are you located? interested in any trades?
  3. I'm located outside of Philadelphia.

    Let me know what you have. There isn't much I'm looking for that isn't pretty specific.
  4. what items are you looking for that are specific. i live in northern VA and can get alot of stuff. let me know at [email protected]
  5. Will consider partial trades for the following...

    1 gallon fuel cell
    Nitrous plate
    10 degree retainers
    C4 - Built
    Electric MKVIII fan or equivalent
    P/S to Manual Steering adapter
    Pulleys for a 351c, 2 groove
    6 cyl w/air springs
    Roller perches
    Subframe connectors
    Rear springs, stock
    Cal Tracs
    Prostars with 5x4.5 pattern (let me know the BS And sizes)
  6. TTT

    Someone wants to build a street motor.

    Buy these and I'll throw in a set of 9.5:1 hypereutectic Flat Top pistons with the same number of miles for just 50 more dollars
  7. TTT

    MAKE AN OFFER. These heads are practically new. I'm losing hundreds doing this but I'm building a different motor now.
Thread Status:
Not open for further replies.