96-04 Trick Flow Track Heat Intake Manifold

Discussion in 'Engine and Power Adder Parts' started by CobraM23, Jul 19, 2012.

Thread Status:
Not open for further replies.
  1. This manifold was on my car for approximately 5k miles. It is the single 75mm TB opening version. I took it off and went with the Edelbrock Victor Jr. because I needed more room in front of the motor to mount my 76mm turbo. The reverse orientation of the alternator the manifold requires will not allow that. It DOES NOT include the intake tubing or intake-to-head bolts that originally came with the kit. It does include MMR billet fuel rails for 96-04 2V.

    The intake retails for $895 but I would like to $500 out of it since its used. I am willing to ship at the buyer's cost. I will only accept PayPal at this time (+3% fee PayPal charges).

    Here is a link to the intake manifold on Summit.

    Here is a shot of the intake installed on my car.

    Edit: As you can see 96-98 cars will have to relocate the D/S coil pack.

    Here is a picture of everything that will be included.
    I can be contacted through here, by email [email protected], or by my cell (four two three)767-nine 7 nine 7.
Thread Status:
Not open for further replies.