Anyone interested in an IRS setup for their Stang?

D.Hearne

New Member
Sep 29, 2000
11,730
4
0
south louisiana
Visit site
Might pick up a 95 Lincoln Mark VIII tomorrow. Going to gut it and make a strip car with the shell. Not going to use the current drivetrain. The DOHC motor has some kind of problem. The owner was told it had a busted piston. But he's not a car guy. Going to sell the engine and trans too. The new drivetrain will be headed by a 331 sixpack, backed by a yet to be determined transmission and a solid rear axle. Anyoine interested can email me or speak up here, unless the Mods have an issue with that. :shrug:
 
  • Sponsors(?)


D.Hearne

New Member
Sep 29, 2000
11,730
4
0
south louisiana
Visit site
The Ranger's been defanged.:rlaugh: I pulled the 331 last year after the "Kid" sucked the intake gaskets in after a romp to 7500 rpms (he let off the gas then in gear, too much vacuum for the gasket top, sucked one down into the port) I replaced it with a milder 5.0, similar in specs to an Exploder 5.0, but with ported E7's and a Ford A321 intake and carb. I just use it to run parts, commute to work when the weather's bad, etc and I don't want to get the 06 Stang dirty. :nice:
 
Thread starter Similar threads Forum Replies Date
0 Anyone interested in a IRS swap Regional Forums and Event Information 2
0 Anyone interested in a IRS swap SN95 4.6L Mustang Tech 4
Cobra Jay Anyone interested in a solid axle to replace their IRS? SVT Tech Forum 2
deathb4dismount anyone interested in giving me $12900? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 20
R Anyone Interested In Hot Rod Lincoln? Other Classifieds 0
Red_LX I have a couple turbo engines if anyone is interested...and some wheels. 2.3L (N/A & Turbo) Tech 3
B anyone interested 2005 - 2014 S-197 Mustang -General/Talk- 3
Begizzle Anyone in the Central PA area interested in doing a transmission swap? 2005 - 2014 S-197 Mustang -General/Talk- 0
wyldpny Anyone interested in buying a new set of Cirvini's Speedster covers? 1996 - 2004 SN95 Mustang -General/Talk- 6
Dan Gray Interesting LIfter Problem.... Anyone else have this happen? Fox 5.0 Mustang Tech 6
Cobain03 Anyone interested in a new stock 65 radiator? Engine and Power Adder 0
1993SSP Photochop my chop, anyone interested? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 3
T Anyone in Columbus interested in doing some Auto work on my car? Regional Forums and Event Information 5
83-88T-Bird Guy Anyone interested in a Stock Appearing race ? Regional Forums and Event Information 0
Slow5.0 Anyone interested in some stickers ? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 2
MTMMAN Anyone interested in a cheap dyno day- Feb 17th Regional Forums and Event Information 31
Therian Would anyone be interested in a flexible Stainless Steel EGR tube? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 10
C If anyone is interested my 66 Fastback build site. Classic Mustang Specific Tech 10
JBeezy53 Has anyone seen this before? (A little long but interesting) Fox 5.0 Mustang Tech 8
S Anyone interested in an HID group purchase? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 0
S Anyone interested in an HID group purchase? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 8
S Anyone interested in an HID group purchase? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 3
S Anyone interested in an HID group purchase? 2005 - 2014 S-197 Mustang -General/Talk- 2
S Anyone interested in an HID group purchase? SVT Tech Forum 0
S Anyone interested in an HID group purchase? 1996 - 2004 SN95 Mustang -General/Talk- 0
S Anyone interested in an HID group purchase? 1996 - 2004 SN95 Mustang -General/Talk- 331
O Gauging Interest : Carbon Fiber Consoles anyone? 1996 - 2004 SN95 Mustang -General/Talk- 12
69clark Anyone interested in an SVT Tribute decal? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 9
Repostyle Anyone interested? Regional Forums and Event Information 10
Red_LX Clutch for sale if anyone's interested 2.3L (N/A & Turbo) Tech 0
lxwants12's IS ANYONE REALLY INTERESTED IN THE SBC POSTS?! Fox 5.0 Mustang Tech 19
n8rsk8r Anyone interested in a P/S pump tutorial with pics? 2.3L (N/A & Turbo) Tech 10
A Anyone interested or have a Carfax account? Regional Forums and Event Information 2
F Anyone interested in swapping to a solid axle? SVT Tech Forum 4
balderman If anyone is interested.... 1994 - 1995 Specific Tech 1
0 anyone interested in the 93 lx on autotrader Regional Forums and Event Information 0
B anyone interested in a new watts link and a 3 or 4 link in here Classic Mustang Specific Tech 167
marcus95 Roush For anyone interested Special Production 11
R Anyone Interested In A Used Blk 05 Gt 2005 - 2014 S-197 Mustang -General/Talk- 4
go-stang5.0 Finally Got Dyno numbers on my combo if anyones interested. 1994 - 1995 Specific Tech 12
KasperG anyone interested in a cheaper way to get a Vortech 1994 - 1995 Specific Tech 0
P Anyone interested in a 1989 Merkur XR4Ti? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 2
jbj454 Anyone in the Gadsden, AL. area members interested in starting a Stang club? Regional Forums and Event Information 3
BLK_DVL Some pics of the C6 for anyone interested Regional Forums and Event Information 19
95strokerPSU Anyone Interested in a Polished Firewall Cover Mustang Sound & Shine All 0
95strokerPSU Anyone interested in a polished firewall cover? 1996 - 2004 SN95 Mustang -General/Talk- 1
95strokerPSU Anyone Interested in a Polished Firewall Cover? 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 26
J Seattle Area Stang Meet? Anyone Interested? Regional Forums and Event Information 59
B anyone interested 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- 2
Red_LX If anyone's interested...I have my old engine for sale 2.3L (N/A & Turbo) Tech 4
Similar threads