anyway to make these work?

[The AntiRice]

is there anyway short of having the pistons fly cut to make thetfs track heat heads work on my car with an E cam? the last owner bent a valve with the combo. so he put the stock heads back on it and left the cam in. he ended up having the heads redone so they are good to go just need to figure out a way to make them work with my bottom end.

 

[FoxNotch]

there is that Isky valve relief tool if you want to make you're current pistons work. Just make sure to use the clay method to check PTV clearance and you'll be set.

 

[The AntiRice]

sounds tricky and could possibly cause some problems. what cam can i run with the track heat heads for the most power but still clear the stock pistons?