Automatic to manual engine conversion question...

Smooth0087

New Member
Mar 11, 2011
6
0
1
I have a 1989 5.0L engine from an automatic car and am putting on a stock T-5. I know i need to get a pilot bearing for the end of the crank, but i was wondering how to tell which position my flywheel is supposed to go on. I always marked mine when i took them off and was sure to put them back on the same way since they have a counter weight. Does it matter what position it goes on? And how do i tell the correct way if it does?
 
  • Sponsors (?)