Have you guys done a timing Chain install? I’ve done my research... however I have one question? I know the marks line up 6 on the cam to 12 on the crank and key way. Was planning to put it at TDC #1 cylinder compression stroke. Is this required or do I just have to line the marks up?
was going to use my finger to find #1 compression and the distributor rotor at #1 to get it. Is this a good way to do this? Otherwise I will get the tdc tool plus the stop. My valve covers are on so I cannot watch the valves, and my balancer and timing pointers are off. Thanks in advance.
I’min here, decent amount of play in the chain and I’m at 138k so figure why not. Again, thanks in advance guys, appreciate it.