Custom fiberglass enclosures

[FallenPhoenix]

I'm thinking about molding some fiberglass enclosures for the wheel wells in my '04 with the Mach1000 system. Right now I'm undecided whether to make them for the stock 10s with a little extra volume to upgrade later, or to make them specifically for 12s that I have yet to pick out. The amps will of course be changed out too. Does anyone have pictures of something like this? I'd like to paint them to match the car too.

 

[MyEarsHurt]

I have a whole thread on how I made mine if you search for it....if you dont want to search for it here are a few pics and one good how to link in case you have never fiberglassed before.

Here is a tutorial...

http://web.njit.edu/~cas1383/proj/main/

 

[FallenPhoenix]

that's about the same method I was planning on using, but molding them to the side wheel wells instead. That's the same tutorial I've been looking at also, specifically this one http://web.njit.edu/~cas1383/proj/Glassing2/index.htm

 

[EpiKk3]

Myearshurt you should just put that whole post in your sig so you dont have to retype it every day

 

[MyEarsHurt]

Myearshurt you should just put that whole post in your sig so you dont have to retype it every day

I know, I did a whole write up on it and everything, but not everyone does a search before they post a new thread...and I feel bad not helping a fellow stang owner.