Do FOX headers fit our cars???

[juiced_94gt]

Im doing a Fox TB conversion and am going to buy new headers for my 331, can i buy 87-93 headers so i dont have the EGR bung?? Are they the same?? will they fit right??? any issues with mid-pipe fitment?? Or should i just buy new 94-95 headers and cap off the EGR (Not as clean looking)???

 

[illwood]

Supposed to be able to run Fox headers. I bought a set, but haven't put them on yet because I want to clean up the GT40's that are going on as well first.

 

[trav_19]

they are the same minus the egr tube nice for doing what you said deleting the egr

 

[final5-0]

If you ever need the bung but have Fox headers ... it won't be good

I'd buy the correct headers myself

Grady

 

[TrueBlue95GT]

Shorty headers from our SN95's are the same as fox headers, but the long tubes are very different. If you use fox long tubes, you have to use a fox tranny and bellhousing along with a fox mid pipe.

 

[Blackened302]

i got rid of my EGR and am running Mac fox shorties w/ a 94-95 X pipe. no problems.

 

[juiced_94gt]

If you ever need the bung but have Fox headers ... it won't be good

I'd buy the correct headers myself

Grady

I ended up getting BBK longtubes, The guy at bbk said that the 94-95 have a different geometry for the longtubes, so i just bought the correct ones and will put a penny on the bung

 

[GT_green_GT]

my long tubes are for a fox body and they fit fine and im using a 95 tranny.

 

[TrueBlue95GT]

I tried MAC and BBK 1 3/4" long tubes and both would come too close to the bellhousing so that I had to get a fox body bellhousing which narrows down closer to the engine and a fox transmission due to the different length input shaft. After that, the mid pipe was off by about an inch and a half so I had it rewelded. You must have been very lucky somehow.