I'm still chipping away! Had way too much fun this summer and neglected my car a little, ok a lot. Things were still getting done even when I was in the mountains or on the beach though. My machine shop moves at a snails pace and finally has my stuff ready to pick up. Block is honed and cleaned, new cam bearings and freeze plugs. Crank is polished and all of the bearings have been ordered. I'm going to have the rotating assembly balanced next week. My buddy wanted to try out his porting skills and hogged out my Victor Jr. intake. That thing is going to flow like crazy now! He also gasket matched the long tube adapter plates to clean them up. I have all of the rust removed and just need to fab up a couple more pieces for the trunk corners. The replacement hinge is in place, but I had to trim too much off to even get it close. I'm not happy with the gaps that I left, but my welder is convinced we will make it work. Metal work is for the birds, in my opinion. I can't wait to build this engine and start slapping parts on this beast!!! Here's some pics...