Flash rate for Raxiom sequential plug and play

ruthiesea

New Member
Jun 16, 2006
3
0
1
I’ve had a Raxiom sequential turn signal kit for a few years on my 2004 Cobra. I installed the V1 flasher. However, they still flash so fast that, unless your looking for it, it’s hard to tell they’re sequencing. I have incandescent bulbs and all the advice I’ve seen are for LEDs, like using an LED load equalizer which I figure won’t work for me. So, I need to add resistors between the turn signal and ground wires.

What Ohm resistors should I use?
 
  • Sponsors(?)