Garage Sale, Yates Heads, C4, Cleveland parts

Discussion in 'Engine and Power Adder' started by 351carlo, Jan 4, 2008.

Thread Status:
Not open for further replies.
  1. 357 Cleveland Shortblock- $800 obo
    -4MA Crank
    -DOAE Rods
    -ARP Rodbolts
    -TRW L2379-F30 Pistons
    -Bored/Honed .030 over with torque plates
    -Approximately 1500 miles since work performed. Includes timing cover.

    Yates/SVO Highport heads C3 Cast 1985 - $2000 OBO
    -Fully polished aluminum heads
    -2.19 Stainless Intake Valve
    -1.65 Titanium Exhaust Valve
    -All fresh pressed in guides
    -Manley Nextek Solid Roller Double Springs (NEW)
    -Manley Titanium Retainers (NEW)
    -10* steel locks
    -Competition 5+ Angle valve job
    -Heads decked and magnafluxed

    Jack Roush/ SVO Intake - $400
    -Converted to 4500 Flange
    -Matched to the above heads
    -Bosses and tapped for fogger system (Plugged currently)
    -Hand ported and blended plenum/runners

    Comp Cams Custom Solid Roller - $300 OBO
    -.3833 Lobe Lift (.661 w/ 1.73 Rocker)
    -256/263 Duration @ .050
    -110 LSA
    -NEW never used.

    Cam Motion Solid Roller Lifters- $200 OBO
    -NEW never used
    -Link Bar lifters

    Package deal- $3500 for the above
    Top end- (Heads, Intake)- $2200
    Bottom end- (Shortblock, Cam, Lifters) - $1100

    Strip C4 Transmission – 300 Miles since new- $1100
    Built by Dynamic Converters in Newark, DE
    Competition (manual shift) - Full manual reverse pattern operation. Also features a billet aluminum servo cover, 5 clutch high drum, high performance bands and clutches.
    Hardened input shaft, solid filled forward drum, rollerized planetary

    Dynamic 9.5” converter- 4500 Stall-300 miles since new- $500
    Features - Dual anti-ballooning plates, triple bearing package, full furnace brazing, all fins are hand welded for extra reinforcement, bulletproof sprag and stator design great for bracket cars or serious street cars. Super efficient.

    Package deal $1500 for both trans and converter.

    1970 351 Cleveland block. Less than 500 miles since machine work. .030 over. Fresh crosshatch.
    4MA Crank- Turned .020/.020
    Matching main and rod bearings for above 4MA Crank. Clevite 77P

    Mallory Comp 32 S/S Distributor- $150
    Ford Racing 9 way adjustable timing set- $50
    Aeromotive S/S Fuel Pump (Red anodized, 1000 miles)- $125

    Will have pictures upon request.
    Contact @ [email protected]
Thread Status:
Not open for further replies.