Forced Induction Head Gasket Help Needed

[mikestang63]

intake gaskets? ebrock performer rpm heads, do they like 1250's or 1262's?

Edelbrock #7220. I don't like the 1250's as they are just paper and are prone to leaks. If you want to stick with Felpro... fel pro ms-93334

Good comparison of the Felpro's

http://forums.corral.net/forums/5-0...334-vs-gt40-ms95952-comparison-lots-pics.html

 

[84Ttop]

I've never had any trouble with the 1250's, i just put a little right stuff around the water passages and away we go. I use the 1262r's on my current setup and have yet to have a leak with them either

 

[madspeed]

just pulled the build sheet and receipts for ths engine. What was used is the 1011-2 head gaskets and the 1262 intake gasket. Shall I just replace the one head gasket with that same part number, keeping in mind the engine has roughly 1500 miles at most or would still reccommend doing both?

 

[madspeed]

1262's do not have the exhaust crossover cutout and neither do my heads, so looks like that one!

 

[84Ttop]

Pull the one side off first and see whats going on if anything. I have just done one side before and had no trouble. Are these heads drilled for 1/2" studs?