Help With Swapping Master Cylinder.

[94GTLaserRC]

Basically, my question is "how do I do this?"

I got a used one off of MyTight's junker.. IM gonna polish it up, then swap it out. Any pics would be helpful.

Thanks
RC

 

[95strokerPSU]

From what I can remember...bleed the brakes, use a socket to remove two nuts attaching it to the brake booster, and then use a wrench two loosen nuts holding the brake lines to the bottom of the cylinder. Pretty sure thats all.

 

[bimmertech]

you gotta bench bleed a master cyl befor putting it on otherwise you'll be azz deep in a four hour bleed job. to bench bleed, find two peices of hose to fit on the outlets of the m/c and loop those hoses back into the reservoir, which should be half full of fluid. place the m/c into a vice and push the plunger in with the plastic end of a screwdriver or other suitable device that will not gouge the plunger. do this repeatedly until all air is removed, now insall the m/c and bleed the brakes in the normal fashion.

 

[Venom351R]

. IM gonna polish it up
RC

 

[mytight95]

lmfao....


man he can't help it, and him, JR, and Mike are starting to get the rest of us hooked, don't deny yourself from the BLING>.....



jason

 

[94GTLaserRC]

Cheap attemp at Post Whoring

Youre no help Chris...!

RC