6\13\07
Dear stang folks
I just replaced balljoints and outer tie rods on my 88 LX.
I thought I did a good job, until I noticed that my left front wheel is sticking out about 2 inches more than my right one.
I pulled the rotor and checked the bearings, everything is as it should be!
I`m thinking now that maybe in the last 20 years that somebody may have used two different sized rotors or spindles.
Any other ideas ?
Thanks
Joe
Dear stang folks
I just replaced balljoints and outer tie rods on my 88 LX.
I thought I did a good job, until I noticed that my left front wheel is sticking out about 2 inches more than my right one.
I pulled the rotor and checked the bearings, everything is as it should be!
I`m thinking now that maybe in the last 20 years that somebody may have used two different sized rotors or spindles.
Any other ideas ?
Thanks
Joe