Thought they'd be ported, those are damn good numbers. Stock or not I;d take those over anything else in that area. Ended up with victor heads with the 2.125 valve we talked about. Had cleaned them up, then when the valve job was done, he plunge cut the seats for me on the inside of the seat. The seats hung into the bowls pretty good casuing a lip.And blend one cyl for me to flow them. I have to still go back and clean of the rest of them still though. Didn't take any "meat" out. But a lot of casting flaws and blending form the original plunge cut when they put in the seats, smoothing stuff out.
Did the drawing for the lower control arm brackets to the rear end today. Added a hole for the shock, and a wheelie bar for saftey. Probably for safety in the beginning, but who knows.