Hi Guys,
I have a 1966 Mustang with a 289, that will not crank or start.
I just replaced the entire enigne loom, under dash loom, and headlight loom. Also replaced the ignition switch.
The car cranked and started the first try, I let the car run for about 15 minutes, turned it off; then tried to crank it again. this time it was a little slow cranking but turned over and started.
I let it run another 10 minutes or so, turned it off and tried to turn it over again.. Click. tried again... Click. nothing.
I've already replaced the silonid, starter, battery, battery cables.
I'm at a total loss. can anyone give me some ideas or advice.
Thanks,
jeremy
I have a 1966 Mustang with a 289, that will not crank or start.
I just replaced the entire enigne loom, under dash loom, and headlight loom. Also replaced the ignition switch.
The car cranked and started the first try, I let the car run for about 15 minutes, turned it off; then tried to crank it again. this time it was a little slow cranking but turned over and started.
I let it run another 10 minutes or so, turned it off and tried to turn it over again.. Click. tried again... Click. nothing.
I've already replaced the silonid, starter, battery, battery cables.
I'm at a total loss. can anyone give me some ideas or advice.
Thanks,
jeremy