Needing opinions

homebulit gt

New Member
Feb 17, 2021
2
0
1
19
Arkansas, united states
I am new here and am wanting other people's opinions on which way I should make my 4.6 2v engine run. I am debating between EFI and carburetor. I am at a predicament cause I have the engine with no intake and I have the engine wiring harness but no pcm for it so can people give their opinion
 
  • Sponsors(?)


MarvinN888

Member
Feb 20, 2021
9
5
13
39
Fargo, FL
Hello, I have an MSD 6A, it used to be on the my father's 240 wagon from auction streaming, now it's on the '63 PV. In both cases, I left everything else on the car's ignition system alone, I just pulled the wires off the coil and hooked those to the MSD input. Then hooked the MSD output to the coil, and wired up the power supply to the MSD.
This leaves everything else regarding the ignition in place and operating normally. If the MSD box dies (My Spark Disappeared!) you can swap back to normal coil wiring very quickly - just unplug the MSD input wires and hook them back directly to the coil.