Ok I got Probe -18.1 CC dish... I was wondering if they will be good enoughfor about 600 rwhp... I have H beam rods with arp 2000 bolts and stage 3 ported and polished heads. Now the reason i ask this is are they dished enough or should I buy a set of different pistons and if I do that that i might as well buy billet rods... So what dish is most people running with forced induction???
Piston Question... With use on turbo/blower!
- Thread starter MoNsTaMaCk24
- Start date
-
Sponsors (?)
FallenPhoenix
New Member
FallenPhoenix
New Member
that's probably why you haven't gotten any answers, are the stage 3 heads the same volume as stock?
white99gt
Founding Member
Probes are new to the 4.6 market.So its hard to say what they will take
CP is the best out there bar none..They have been used in 1000+ motors with no issues.
Unless you plan on racing the car and making in excess of 700+rwhp stick with the h beams .Many cobras are usung them in the 600rwhp range with no issues..
CP is the best out there bar none..They have been used in 1000+ motors with no issues.
Unless you plan on racing the car and making in excess of 700+rwhp stick with the h beams .Many cobras are usung them in the 600rwhp range with no issues..
cobranos
Founding Member
I run MAHLE 16cc dished pistons in my stroker with I beam rods.........Never had a problem with the setup......
white99gt said:
really? first pistons i heard about in the aftermkt were probes, and that was a long time ago.
Similar threads
