Power Window Problem

[bigcahoona]

OK I was out yesterday with the windows down and when I got home the passenger
side window does not go up. No noise no movement. Just nothing. Never any sign that the window was having a problem. Any ideas before I start taking this thing apart ?
88 LX Hatch not a Vert.

 

[jammer84_03]

as bad as this sounds, give the door a good thump with your fist right where the window motor is. i had to do this once when it hung up. should do the trick. it will give the motor enough of a jar to get going. if not take the door panel off and then the speaker (if you have one in the kick panel location) and give the bottom of the motor a tap with a hammer. should un- freeze it

 

[93 LX]

did you try the switch on the passenger door? It could be the switch on the drivers panel.

 

[monte87]

Sounds like an intermnittent window motor prob.. probably you will have to replace it soon.

Later Ant
P.s. that is how it usually rears its ugly head in the beginning.

 

[cenok is family]

hah my window just did the same thing. it was a lot slower than my driver's side and would randomly give me hell trying to get it back up. i'm pretty sure my motor's shot. i'm going to try the little thump on the motor thing to get it back up for the time being though.

 

[93 LX]

check the gear that drives the regulator. Most of the time the plastic bushings go bad causing the motor to bind.

 

[jrichker]

Remove the door mounted speaker & the upholstery panel to gain access to the motor. There are 3 screws (5/16" hex head, I think) that secure the motor in place. Remove them and the motor comes out without any problems. Once you remove all the screws from the motor, and it falls away from the gear teeth on the arm for the glass, the glass will move up and down. You may need a helper to hold the glass once the motor screws are out, since the gear on the motor holds the glass from sliding up or down

The motor is the same for left side or right side, only the gearboxes are different. If you can't find the complete assembly for the side you want, you can get either side and use the old gearbox on the new motor.

The gearbox has 3 plastic rollers that are a safety clutch to prevent possible injury if the window is rolled up while something or someone is hanging out the window. The plastic rollers will often disintegrate into chunks of plastic and the window will no longer roll up or down. The Help! section of your local auto parts store will have the replacement plastic rollers

Wiring diagrams courtesy of Tmoss & Stang&2birds
http://www.veryuseful.com/mustang/tech/engine/images/mustang87-92 PowerWindowWiring.giff

http://www.veryuseful.com/mustang/tech/engine/images/mustang93PowerWindows.gif

See the following website for some help from Tmoss (diagram designer) & Stang&2Birds (website host) for help on 88-95 wiring Mustang FAQ - Engine Information Everyone should bookmark

 

[bigcahoona]

Well the hit on the door didn't do it so I guess it's time to take it apart.
Thank's for all the info.

 

[Foster9887GT]

Boy, these cars are a trip. Mine does the exact same thing once in a blue moon...

 

[monte87]

Forget about hitting it, banging it, hoping it will go up, praying this and that. bottomline-You need to fix it. That is the only thing that will be a permament fix anything else is a band-aid. Its a cheap fix, You should do both and be done.
if it make you feel better, i had an 87 lincoln CONTI once and went through 8 passenger side window motors, rebuilt of course. Until i stepped up and bought a ford new replacement-neever had a prob again. this is why-I say, Stop fooling around, Because **** happens in the worst times. Like being a really bad neighborhood, need to raise your window and Bammmmmmmmmmmmmm-It wont go up! hahahah thats happened to me as well. Just preaching what i practice.
Good luck, Ant