Ricer vs 2.3T, lmao
- Thread starter Mr. Merk
- Start date
-
Sponsors (?)
Shawneebear93
Dirt-Old 20+Year Member
Some people are so ignorant (even I almost bought a Prelude). Just kidding, Hondas are good cars if you do it right, but too many people don't and that goes for cars of all makes.
79'293stang
Active Member
wow that guy is retarded, does he forget perty much every engine is still running on a concept that is over a hundred years old no matter what fancy gismos you strap on top of it.
i'm a mod, its also known as nwamotorsports
i've been there since the beginning, waaaay before my 2.3T days
i've been there since the beginning, waaaay before my 2.3T days
And remember, these people drive with aluminum...I've seen a ford 2.3T push 35+psi and the only thing it did was blow the stock headgasket (I think it was the 4 Banger project) and I doubt some aluminum head can handle 35psi, a 338% increase in power. That same car also ran in the 10s later on I think it said, maybe faster if someone wants to correct me, and for a 3500lb car it takes at least 520 hp to run a 10.998 according to formulas so it could be off some.
Stinger
Founding Member
Well, the 4 Banger project ran low 12's, not 10's. It's also closer to 2600-2700 pounds. Probably 350hp or so.
Well I did a search to find the car I was thinking about. This thread has a post with a video of a 9.3s SVO: http://forums.stangnet.com/showthread.php?t=538917 or just click this link for the video: http://projecthp.ford23.com/Videos/2.3T9.30SVOJDB.mpeg That just shows the power and potential of the ford 2.3 block.
Similar threads
