Subframe connectors - I know I need them, but there are a ton of options out there. Looking for advice from the community, seeing if there is a consensus best option for my car. Clean, rust free 89 GT, ~300 rwhp range. I admittedly don't know much about the differences between all the brands/options. Yes I looked through the forums before posting.
subframe connector recommendations?
- Thread starter TomOsiris
- Start date
-
Sponsors (?)
Maximum Motorsport full length. Weld in. You can get them bare and finish yourself after they are welded in or powder coated, but the powder coat would have to be taken down to bare metal at all the welds anyway for a good weld.
Wolf_Fox
Member
I actually have always preferred to build my own. The cost of some steel tubing is considerably cheaper than any pre-fabbed options on the market. And they get welded up anyway. 
There are tons of schematics around also.
There are tons of schematics around also.
