Hello guys, I was told to come here for some input regarding my newly turbocharged 351W. I have been running the engine (N/A) and trans on an MS3x and Microsquirt for the last year, but I couldn't call my tune optimized.
The motor is a stock F4TE short block, Comp XE266HR cam, SVO Lightning lower and Explorer upper intake, 70mm TB, 60cc chamber BluePrint Engines cylinder heads (should make for 9:1 compression), DNA "GT45" turbo, 4" dump to dual 3" straight-through exhaust. MS3x + Microsquirt trans control, 40# Accel injectors, FiTech HyperFuel surge tank/pump ("supports 800HP"), stock TFI ignition.
On paper this engine should be about 350HP. I have a "5-pound" spring in the wastegate, but it's eBay stuff so I'm not sure what to expect. Per injector calculators, I have enough injector for about 550HP at 85% DC. Not looking to blow my transmission up right away either, so I'm hoping to keep the power modest.
Transmission is a 4R70W with a shift kit and I have a 3.70 ratio axle.
I've attached my current tune. Again, it's drivable (I've put thousands of miles on it), but I don't claim it to be otherwise good or optimized. I have done some offline tweaking in the boost range but the engine hasn't been run on it. I'm open to all suggestions if you see something strange.
I'm hoping to have the exhaust system finished or complete enough to drive this coming week, so I will be able to make some logged runs soon.
Thanks!
The motor is a stock F4TE short block, Comp XE266HR cam, SVO Lightning lower and Explorer upper intake, 70mm TB, 60cc chamber BluePrint Engines cylinder heads (should make for 9:1 compression), DNA "GT45" turbo, 4" dump to dual 3" straight-through exhaust. MS3x + Microsquirt trans control, 40# Accel injectors, FiTech HyperFuel surge tank/pump ("supports 800HP"), stock TFI ignition.
On paper this engine should be about 350HP. I have a "5-pound" spring in the wastegate, but it's eBay stuff so I'm not sure what to expect. Per injector calculators, I have enough injector for about 550HP at 85% DC. Not looking to blow my transmission up right away either, so I'm hoping to keep the power modest.
Transmission is a 4R70W with a shift kit and I have a 3.70 ratio axle.
I've attached my current tune. Again, it's drivable (I've put thousands of miles on it), but I don't claim it to be otherwise good or optimized. I have done some offline tweaking in the boost range but the engine hasn't been run on it. I'm open to all suggestions if you see something strange.
I'm hoping to have the exhaust system finished or complete enough to drive this coming week, so I will be able to make some logged runs soon.
Thanks!