What do you think of this cam?

[stockstang50]

I wanted to yall's opinion and ask a few questions anbout the cam i just bought for my car. I couldnt pass up the deal on it, I paid $25 with shipping from Cam Motions in Baton Rouge. Thhey were having a clearence sale so I jumped all over it.
From what I can tell from the spec sheet is that is a nitrous/blower cam. My question is what do I need to make it work in my car? How bad will it lope, and maybe what kind of gains?
Im asking yall because it was an internet only sale and I couldn't ask the guys at Cam Motions. My mods are in my sig and that is all I have so far.

Thanks
Ben

 

[stockstang50]

internet wont let me attach it so ill type it
Intake & Exhaust
Lobe seperation 111 cam deg
Valve overlap -.3
Intake
valve open .2 deg.s BTDC
centerline 107 deg ATDC
valve close 34.4 ABDC
duration 214.6 crank deg
lobe lift .29394 IN.
valve lift .4703 in.
lobe area 22.46 in * deg
Exhaust
valve open 49.5 degBBDC
centerline 115 degBTDC
valve close -.5 degATDC
duration 229 crank degrees
lobe lift .29976 in.
valve lift .47962 in.
lobe area 24.46 in*deg

This with 1.6 rockers

 

[Joes95GT]

Too much duration, not enough lift and a centerline that will make the ECC go berserk.

Joe

 

[VibrantRedGT]

Way better choices out there. Use 1.72 rockers and cross fingers for a non-surging idle. If not this cam could cost over $500 (custom burned chip).