I just got my prochamber in the mail and I was wondering if I need to use that flared peice of metal that goes into the driverside header? Also will I have to use it if I get the manifold stud kit from Napa?
Thanks.
Thanks.
mity2 said:i would just to be sure. can't remenber id 04 frange is smaller or bigger..
yes...you need the stud kit from napa...I had a prochamber on my car and had a nice leak on the driver side....I didn't feel like messing with it so I put the stock h-pipe back on...I am seriously thinking about putting the prochamber back on with the stud kit.TorchRed04GT said:Did you use the stud kit from Napa too?
black04stang said:yes...you need the stud kit from napa...I had a prochamber on my car and had a nice leak on the driver side....I didn't feel like messing with it so I put the stock h-pipe back on...I am seriously thinking about putting the prochamber back on with the stud kit.
well..the prochamber I used was giving to me...U think like 2 years old and never usedMossberg said:That sleave on the left side is there so you don't have to use the stud kit. Mac added that after the complaints with older Prochambers. I didn't use the stud kit and have no leaks. I did replace the passenger side gasket just in case though. It couldn't hurt to use the stud kit anyway to be safe.
TorchRed04GT said:I just finished the installion today. I replaced the manifold studs and replaced the passenger gasket. No leaks yet.
I did run into a little problem with the driver side front o2 sensor because the wire was not lond enough. I just uncliped the harness from the plate that it was attached to and it gave me enough room for it to fit.
The thing sounds so bad ass, I don't know why I waited so long to get it I wish I would have gotten it sooner.