I have a 3310 Holley carb and had 2 questions as I'm rebuilding it.
question 1: I tried using a rubber mallet to get the primary metering block loose to no avail. is there a screw that I am missing or some trick to getting this loose.
question 2: on the secondary metering block there are these funky screws that have an oblong hole in them. first I assume I need to remove these to get the secondary metering block off or am I wrong? what do I use to get them out if I need to? I have to replace the gasket.
thanks for any help!
question 1: I tried using a rubber mallet to get the primary metering block loose to no avail. is there a screw that I am missing or some trick to getting this loose.
question 2: on the secondary metering block there are these funky screws that have an oblong hole in them. first I assume I need to remove these to get the secondary metering block off or am I wrong? what do I use to get them out if I need to? I have to replace the gasket.
thanks for any help!