Anyone interested in a cheap dyno day- Feb 17th

[wythors]

If you want, PM me your email address and I'll forward the info.

 

[MTMMAN]

email me to make sure you have a spot.
I have the following on the list.
frcefedlx
cobradvm
84Gt350
bill89saleen304
hyper00
Make sure you email me to save your spot. There are only a couple spots left.
The Dyno day will be at Horse Power Ranch
Horse Power Ranch is not the group putting on the event, it is being held there. So please don't contact them, contact me.
Cost will be $25 for two back to back power pulls with a A/F ratio.
Horse Power Ranch is located at-
28403 SE 204th ST
Maple Valley, WA 98038
Starting time 9AM
Please make sure to reserve you spot as space is limited. There are only a couple spots left. People are welcome to come down the just watch too. Sorry for the delay in responding, I didn't get on-line all weekend.

 

[Tylerb59]

Dannnnnng that's far south.

I think I'm going to be heading east toward Ellensburg that weekend so I can't commit. I'll try and swing by as a spectator though.

 

[99GTtony]

Dane,

Do I have a spot?

 

[MTMMAN]

Its looking like the list is full. If you emailed me you should have gotten a response now. People should feel free to come by and watch also.
It looks like we should have a Chevy Vs. Ford shoot out. There should be a 2007 ZO6 showing up. There will be several 03/04 Cobra's.
Make sure you bring cash to help speed up the process.

 

[2bfeard]

Dyno

How much horsepower will there dyno hold? I could bring my 101mm turbo 93 cobra. What size is the drum on it, is it 60 inches or bigger? That's just down the road from me.Thanks Gregg

 

[MTMMAN]

Greg, you should come by either way. People who haven't seen your car would love to check it out.

Our shop was designed around dyno tuning and is the most advanced tuning facility available. The dyno cell features an in-ground Mustang 1750 Dynamometer capable of measuring in excess of 2,000 horse power and chassis loading in excess of 1,000 horsepower. The cell features advanced air evacuation that moves 20,000 CFM of air through the cell during a dyno run - something most shops don't have. It has been proven that to get repeatable and accurate results you need to move 7,500 CFM per every 500 wheel horse power otherwise you run will be bringing in spent exhaust gasses back into the intake air of the engine. Our cell can properly circulate air for up to 1,400 wheel horsepower. The facility also features a giant 32" display screen on the dynamometer so that the customer can see exactly what is happening during every run.

 

[Silver2003Cobra]

if I'm not doing anything.. I'll show up just for the hell of it..

I already have base numbers, (on both a Mustang and a Dynojet) but will be cool to just see what others make..

 

[99GTtony]

Who's going tomorrow? Anyone wanna meet in Seattle and cruise from here?

 

[bill89saleen304]

Hey Tony,

I'll see ya down there I'm meeting a couple of friends at Clearview about 7:30 am
and we're cruizing down together!
Jack if you read this shoot me a PM



See Ya Bill

 

[MTMMAN]

See every one there. It should be a blast.

 

[frcefedlx]

I wont be able to make it after all, ran into some issues with the HCI swap and need to iron out the problems. Have a good time.