GT40 heads, non-P
- Thread starter mustangjoe87
- Start date
-
Sponsors (?)
1985 5.0
New Member
Aliate X
Member
lol the P's are better than the non p's.....Id never pay 450 for a set of those, nevermind the fact you can get a set of used aluminums for not much more.
Aliate X
Member
Aliate X
Member
and here you go
http://www.corral.net/forums/showthread.php?t=898831
$650 shipped
$750 with 1.7 SVO rockers
http://www.corral.net/forums/showthread.php?t=898831
$650 shipped
$750 with 1.7 SVO rockers
I looked at those already and determined that there were not what I wanted
8 new intake valves - why not replace exhaust valves
new valve seals on one head - what about the other
O-ringed - Id rather push a head gasket than a short block
Truck smoked a little - you sure it was the rings?
8 new intake valves - why not replace exhaust valves
new valve seals on one head - what about the other
O-ringed - Id rather push a head gasket than a short block
Truck smoked a little - you sure it was the rings?
Aliate X
Member
If you have any boneyards near you, a set of heads can be had for around $30 each. That's where most of the ones on eBay come from. I went to one of my local boneyards a while back and saw two sets of P heads and 4 sets of non-p heads. I grabbed the P-heads for myself for $50, and decided to put them on eBay....got $400 for them.
1985 5.0
New Member
so the p-heads come on 98+ 302 explorers, anything else?? is there a way to identify these heads
Sure I could get them for cheap, but I would still need a new set of springs and gasket match. These heads already have that done and only 3k miles. I just want to know what other paid for theirs that have similar work to these.
