fuel pressure gauge on bbk fuel rails

[ll2none]

i just put the bbk fuel rails on my motor, i want to put a fuel gauge on. but i dont see how to do it. the rails dont have a place to put the fitting for the gauge like the stock rails had.. any suggestions...

 

[mikepotts]

did you use an aftermarket FP reg.? if so it might have a port, like my aeromotive does. if not, check the steel fuel lines that connect to the fuel rails, the inlet line should have a port as well.

 

[wbrockstar]

steel lines

the fuel pressure gauge connection port(also known as the shrader valve)is not located on the fuel rails at all,its on your metal fuel lines.go back about 5 or 6 inches from the disconnect fittings on your fuel lines and youll find the fitting.it might have a metal or plastic cap(kinda like an ac refrigerant fittng)screwed on top of it.passenger side near maf meter.thats your connection port

 

[mikepotts]

what did you find out on this? any solution yet? i noticed your FP reg. didnt have a pressure port like mine does.