So finally today me and my buddy got the car running today...i have been workin in it since last september ...its a built 306 svo aluminum heads...not sure on the cam i know its 530 lift..heads ported and polished ...trick flow fuel system..upper and lower intake also trick flow..accufab 75mm tb 30 lb injectors...i knowtheres more but i cant think if it all..everything was replaced..this is a total different block from before...we ran it timing was off and had to much fuel pressure so it got flooded ...im gonna get a new distributor cuz i cant stand the stock one..i need a skinny billet one...so all i got left is to get the timing on point again fuel pressure right and then i looked under the car and saw oil dripping from where the plate bolts up to the block in between the bellhosing..what could that be? i put a new rear main seal in...it was a good size spot on the ground other than that its almost ready it sounded like a beast heres some pics
From this
View attachment 222378
to this
View attachment 222379
View attachment 222381
From this
View attachment 222378
to this
View attachment 222379
View attachment 222381