Hi,
I just measured a replacement shaft I had from my TCP install and it's 5/8".
It's supposed to be the correct dia and thread pitch for a 65 steering wheel nut.
Hope this helps and good luck with the re-thread, or else?
I hate to think of the alternatives.
Thanks for the help. Yes i am going to try and rethread, if not i am going to cut the shft where the threads are and weld on a new piece. Not the best alternative but it wont cost me anything but time.
Thanks for the help. Yes i am going to try and rethread, if not i am going to cut the shft where the threads are and weld on a new piece. Not the best alternative but it wont cost me anything but time.