When I push my clutch pedal in it starts to squeak as it gets close to the floor and then it really squeaks as it travels back to its normal position. it only makes the noise when the pedal is traveling. I have been doing some research and it sounds like it could be the throw out bearing which would suck because I just installed a new one with new clutch, pressure plate and flywheel when I put the explore motor in. I have a 3 hook quadrant and I have my cable on the last hook so it is as tight as it can be. I am wondering if this can be creating the squeaking because it is too tight. my clutch pedal is about 2 inches above the brake pedal. Should I have it on the middle hook? would this be causing the squeaking?
I believe my cable is a stock cable and I do not have a firewall adjuster.
The squeaking sounds like a door that needs to be oiled.
Thanks!
I believe my cable is a stock cable and I do not have a firewall adjuster.
The squeaking sounds like a door that needs to be oiled.
Thanks!