Search results

  1. T

    Idle Comes Down Slow After Heads & Cam Swap

    Here is a list of my mods for reference: Smog Delete Ac Delete PS Delete with FlammingRiver Manual Rack and Pinion Spare, stereo, rear seat, jack gone Engine: Running only Alt, water pump, and crank pullies u/d Pullies MSD coil, Summit Billet Dizzy w/ MSD cap and rotor, FRPP wires...
  2. T

    Is fiberglass really that bad??

    I bought "almost a year ago" a Full cobra R body kit that is Fiberglass, and I am finally almost ready to get it put on but am having 2nd thoughts. Is fiberglass really that bad, and anyone on here useing a fiberglass bumper or anything?? Should I stick that FG Cobra R front bumper on the 2000...
  3. T

    What do you guys think??

    So i just got my shift kit in and i picked up the car and the tech wanted to talk to me ... I was like ummm this aint good, so i got back to the cave and he greets me and goes right into this spill: "to begin with your shifts were really soft and when i took out the VB on your tranny i...
  4. T

    Low cars and mud don't mix!

    I have a short story for you all. I just installed my new Steeda short throw and wanted to test it out, so I went to my friends house to see what he is doing. He lives in a trailer park and the 1st speed bump is really big. I have a 2000 Gt with the cobra R front bumper and it is lowered around...
  5. T

    Rough Idle and popping on Passinger side

    Ever Since I put my long tubes on I have had this problem :bang: of a very rough idle and when I try to accel and i give it gas it back fires on my passinger side 2 to 6 time then picks up real fast and accels. then at any crusing speed the whole car is jumpy. I have already replaced the spark...
  6. T

    How much money

    How much money would you give for a set of used trickflow heads with 1.6 roller rockers and push rods. it has all the blots but missing two washers. they look like there well used in the means of the runners dark black from carbon and the combustion chambers are dark from use, i noticed two of...
  7. T

    I've got Problems

    OK so here is how it goes, 2 weeks and some change ago I put Mac L/Ts on and completed the install, now during the install I have replaced the spark plugs. Now I have noticed that after wards I had the check engine light on but didnt really notice anything was going wrong until last friday, up...
  8. T

    Need help fast!!

    Hey I am trying to install these mac long tubes but even with the engine jack up I cant seem to have enough clearance to rout them through. and on the drivers side the steering shaft is in the way, I tried to remove it but dont know how. I only have today to get this done so Anything to make...
  9. T

    Mac Long Tubes

    Hey ya'll, I just got my MAC long tubes today and H-pipe. In the install instructions they say to unscrew the motor mounts a little and raise the engine up to install them. Do I need to do that? Thanks for the help.
Top Bottom
Back
Forums
Menu