Search results

  1. D

    Damaged Driveshaft Questions

    Hey guys I have a couple quick questions. I have an aluminum driveshaft that I took off my Mustang before I sold it. It had rubbed up against the ebrake bracket and has a gouge in it. I took a set of calipers to it and its roughly .02 inches deep. Is it worth selling or should I just scrap it?
  2. D

    FS: 1994 Mustang GT Vert in PA

    I have a 1994 Mustang GT convertible 5 speed for sale. 122k miles Mods include: GT40 Tubular upper and lower intake GT40 Y Aluminum heads FMS Shorty headers Summit O/R H Pipe Borla Catback Cobra front brakes 65MM Throttle body ASP Underdriven Pulleys B&M Ripper short shifter HD Clutch w/10k on...
  3. D

    Overheating

    Hey guys I'm hoping that you can help me out. My car is overheating. It's fine at idle till it gets driven then spikes to the L and above. At first I thought it was the waterpump because it was leaking. I've replaced that as well as the thermostat because I thought it was bad too. At first the...
  4. D

    What would cause....

    Gas in the upper intake? I took my upper off a few days ago and found alot of gas covering the sides of the intake. What would cause this?
  5. D

    Quick question/need opinions....

    Ok guys, I dont post very often here but I have a question about this. I've got a for sale ad going on for my side exhausts and got a bite on them. Which is great and all but it seems just a little fishy to me. This is what I got in an email. I just want your guys opinions on it. Thanks...
  6. D

    E-Brake light and others

    Ok so I was out at an autox, just finished a run, and the tires were very sticky. Unknowingly I parked on the timing light wire which is just some CAT-5. But anyways, it wrapped up in my rear suspension and since then my ebrake light stays on. I'm assuming that I put some pressure on the cable...
  7. D

    Lowering question

    I just put on the Eibach Prokit and new KYB struts and shocks on my car. Now when I turn they appear to be rubbing the control arms. Has anyone ever had this happen before? If so what did you do to fix it?
  8. D

    First autox vid...

    This is the first autox vid I have seen of my car, check it out and let me know what you think. Video
  9. D

    New Injectors

    Hi guys I'm new here. I just bought a 1994 Mustang GT with quite a bit done to it. Now I'm not great at motor work by any means. Heres my problem. I changed my injectors to 24# and put in a GMS 75MM MAF. No big deal right? Well my car now runs rough as hell and occassional stalls. I then changed...
Top Bottom
Back
Forums
Menu