Search results

  1. L

    starting issue

    it seems most of the time when i go to start my 86 with a 2.3, auto if that matters at all with a carb. when i turn the key to the start. it will start right up. but as soon as i bring the key to the run position its like i turned the engine off. takes 3-5 times before it will stay running...
  2. L

    power brakes to manual

    on a 86 coupe can i remove the brake booster to convert to manual brakes with out a $90.00 adapter ? thats a ton of money for a small piece of aluminum with a few holes in it. i have done this on a Oldsmobile before the master cylinder mounted to the stock booster location and i shortened the...
  3. L

    were is my spout conector ?

    i need to put a timing light on my 86 with a 2.3 with EEVc-IV. where is the spout connector at ? on my 85 bronco II with a 2.8 it was a single wire connector about 12" from the dist. i can not find a single wire with the same type spout as on the broncoII i did find a plug with the same style...
  4. L

    trans line fitting at the radiator leaks bad

    i needed to remove my radiator on my 86 and after i put the same radiator back in . now the lines are spewing trans fluid out of the fittings yep there tight. i can tighten up the fittings and i can still move the lines in and out about one inch still. never leaked before i took out the...
  5. L

    need help bad

    i started to change my timing today. so far a large pain in the rear. every thing was going ok till it came time to remove the crank pulley. got the bolt off. what the heck is the secret to removing the darn thing ? i have some pullers but there are no threaded holes to use any puller i have...
  6. L

    rag joint where to buy. ford?

    where do i buy a rag joint for my 86 stang ? orielly, napa,autozone,advance. dont show them listed. not going to buy a flaming river one for $ 300.00 where did you buy one and how much ?
  7. L

    my 1st stang 86 / 2.3

    it took me from 1964 to get a mustang. it's not pretty thats for sure. if i did it right there is two pic;s of it one week before i got it. it's filthy dirty as you can see. i got it last Thursday 6/22/07 so far i filled a 5 gal pail if dirt, papers, mouse nests. speaker wires all over the...
  8. L

    need vin decoder help

    i'm putting this here because i have no idea where else to put it. i need some help on the door plate how to decode it. the vin i was able to do but cant find any thing on how to decode the rest. so here goes. GVRW 3725 front GVRW 2172 rear GVRW 1981 exterior body 568 int. trim FA R E4...
Top Bottom
Back
Forums
Menu