Search results

  1. Grn92LX

    Electrical Intermittent battery/charging issue

    Other day was driving home and noticed my battery gauge (holley digital dash) reading just over 12v. Normally it reads around 14.4v. Made it home, put the battery back on the trickle charger and thought all was well. Drove the car around a few times since and no issues, battery gauge was showing...
  2. Grn92LX

    Electrical Female terminals in inertia switch harness?

    Probably a long shot here but anyone know the female connector type used in the inertia switch harness? I’m looking for ones that can accept a larger gauge wire since I rewired my fuel pump to 10g. Thanks
  3. Grn92LX

    Electrical Rewiring Ignition coil..Opinions on 2 options?

    Im just about finished wiring up my relay panel hidden underneath the front seat next to my Holley ecu. Im trying to figure out the best option for the ignition coil. I have 2 options: a 10g output from the relay to a step down butt connector to factory TFI pig tail Or A straight 16g wire...
  4. Grn92LX

    Fox Reasonably priced bluetooth stereo for fox body?

    Whats good and fits the fox dash? Looking for a bluetooth radio so I can use my phone for music. Don't need cd/dvd. Links? Thanks
  5. Grn92LX

    Engine How to check for lower intake vacuum leak at lifter valley?

    How do you test and/or check for a lower intake vacuum leak at the lifter valley? Thanks
  6. Grn92LX

    Electrical Jumping alternator dash wire after digital dash install?

    Just looking for verification. Im in the middle of installing my Holley efi 6.86" pro dash. I know I need to jump the wires on pin 2 and 14 on the factory harness to turn on the alternator. Can I just run a simple 14g wire jumper or does it need a resistor soldered in? If so does anyone know...
  7. Grn92LX

    Digital Tuning Anybody running a Holley efi Pro dash?

    Thinking about getting one for my car. Already running holley terminator x. How do you like it? What did you do for the battery gauge alternator 12v signal wire?
  8. Grn92LX

    Digital Tuning Anyone know the distance between the injector and valve seat?

    Looking for the distance or close estimate of the injector to the valve seat on a twisted wedge head?
  9. Grn92LX

    Drivetrain Anyone using a modern driveline hydraulic conversion?

    Looking at buying it and wondering if anyone is using it? http://www.moderndriveline.com/Technical_Bits/Fox_Hydraulic_Clutch_Install.htm
  10. Grn92LX

    Msd Starter Vs Powermaster Xs

    Looking at aftermarket starters that can handle compression and heat soak. I'm looking at either the msd 5090 or the powermaster xs 9503. How has it been working and whats your compression? Looking to replace my old PA performance starter that can't keep up with my car anymore.
  11. Grn92LX

    Question On Converting Car Back To Pcv Valve

    I'm running an edelbrock victor efi intake which does not have pcv provisions. I am in the process of converting back to pcv valve from a vented breather tank. I bought a set of Ford Racing valve covers for a carbureted car. My question is, the hose that goes from the oil fill to the TB..Does...
  12. Grn92LX

    Anyone Using A Stinger Pimp Ecu?

    How is the user friendliness of it? How do you like it?
  13. Grn92LX

    Anyone Running A 331/347 With Tea 205cc Tw Heads?

    Looking to see what kind of numbers n/a you're making. Dyno numbers, graphs, track times if you have it. Just picked up a set this week.
  14. Grn92LX

    Suspension Street/strip Front Coil Over Set Up?

    Looking into a coil over set up. Been looking at the upr stuff, strange and MM. What's everyone running and why? Whats the recommended spring rate for street and strip? What street/strip struts are you using with it? I was looking at the adjustable strange struts.
  15. Grn92LX

    Anyone Using The Holley Efi System?

    How do you like it? User friendly? How would you compare it to an anderson pms?
  16. Grn92LX

    Brakes 13" Cobra Front's With Gt Rears?

    Can you swap to 13" cobra front brakes while keeping the gt/v6 rear disc brakes? Setup consists of 99+ pbr fronts with a 93 Cobra mc/booster, nrc rear caliper brackets with fox 31 spline axles, all MM steel braided lines front & rear and a ford adjustable prob valve.
  17. Grn92LX

    Electrical Headlights, Turn Signals, Hazards Don't Work

    I can turn the headlight switch on and the dash gauges will light up but headlights won't turn on. If I turn the blinkers on, the arrow on the dash will stay on solid and same for the taillight blinkers just stays on solid. Hoping for a simple fix. Any idea's?
  18. Grn92LX

    Brakes Brakes Don't Feel Right After Sn95 Swap

    Recently completed an sn95 swap using 94 spindles, 99+ PBR calipers and 94+ rear disk. I used a 93 Cobra mc with the maximum motorsports adapter kit, gutted the stock proportioning valve. I used the maximum motorsports rear disk line kit with ss hoses. Stock rubber hoses up front. 31 spline fox...
  19. Grn92LX

    Summit Racing Manual Rack Kit

    Anyone using it? How was the overall fit and quality? Part # http://www.summitracing.com/parts/sum-770605
  20. Grn92LX

    Brake Fluid From Rear Caliper At Parking Cable Bolt??

    Just finishing up a 5 lug conversion. Started bleeding the brakes today and found fluid leaking from the parking brake bolt that holds the lever. Parking brake isn't hooked up yet if that matters. Why?
Top Bottom
Back
Forums
Menu