Search results

  1. N

    Another coolant thread

    I noticed a little bit of coolant sitting on top of my water pump when I was pulling my dizzy today... Any thoughts where this came from? Excuse to buy an electric water pump:shrug:
  2. N

    Wont rev past 3krpm - tach jumps around

    Car is being dyno tuned and it wont rev past 3k rpm... The tach in the dash bounces around like crazy.. Any ideas what it might be? Car is running an AEM standalone, Spout is plugged in -- I'm thinking its distributor or TFI module.. ?? Thanks
  3. N

    TPS adjustment - couldn't find answer

    I searched and couldn't find the answer to my problem.. soooo I installed my AEM stand alone yesterday.. Went to adjust the TPS since it was showing 3.03 volts on the standalone (showed about the same on a multimeter) I can't get it to adjust down to lower than 2.02 volts on the...
  4. N

    Steering Wheels

    Mine is all sorts of nasty.. Leather worn through at the top.. busted buttons for the cruise control... etc etc.. Thinking about going for an aftermarket wheel (minus air bag and all that jazz) Don't figure I'll need an airbag since i'll soon have a full cage, seats and 5pnt harness in the...
  5. N

    Fuel line disconnect from fuel rail/FMU

    So I'm trying to remove the fuel lines from the return port on the rail, to the paxton fmu... I bought some of the metal tools to remove fuel lines from auto zone (set of 4, alum, anodized..) Anyways, the biggest one in the kit is a 1/2" ... and its to small, it doesn't fit around the...
  6. N

    What are these lines

    Hard lines... The red one is hooked to a vacuum port, the green one runs to the EGR valve.. The other ones weren't hooked up to anything, but I would suspect they likely connected to the stock intake considering their length and bends.. The connector looks like it was for 3 wires (red, green...
  7. N

    3bar GM style MAP sensor install

    So I'm installing a 3bar GM style MAP sensor in my car to work with the AEM standalone I purchased So I need to connect 3 wires for it A. is ground B. is signal wire to ECM C. is 5v signal wire Pretty easy over all.. However, is there anywhere under the hood I can get a 5v signal...
  8. N

    Finally ordered parts but some more questions too!! :)

    Finally got off my butt and ordered parts for my mustang.. (after asking a **** ton of questions on here.. ) Ordered: 70mm FRPP throttle body 42# FRPP injectors AEM Plug-N-Play computer GM style 3bar MAP sensor and a new AIT I still have a lot of things to do to it after I get these...
  9. N

    Questions about a build up I'm planing

    I'm new to working with 5.0's .. So i'm learning as I go.. I made a post a couple weeks ago but am thinking of going a slightly different way with the build... so a few more questions... The project car I bought has some issues that I'm trying to remedy So heres what the car has done to it...
  10. N

    94 GT with lots of issues.. but what MAF should I go with?

    I bought a 94 GT thats had alot of issues i'm in the process of fixing.. It has a paxton S/C kit on the car... forged bottom end, gt40 heads.. edelbrock performer upper and lower intake.. etc... I've decided to do some upgrades while i'm fixing the issues with the car.. I'm steping up...
Top Bottom
Back
Forums
Menu